JVC Model SR-TS1U Instructions Manual page 33

Using two sets of SR-TS1U, you can play back two cassettes
alternately as many times as you want. You can select the
returning position for Series Playback (
Use the buttons and controls on the VCR's front panel for
the Series Playback operations (except when using Mode
Lock).
MAKE CONNECTIONS
1
Connect two sets of SR-TS1U and a TV using AV cables
as shown in the illustration on page 32.
The mini-plug cable is a mono 3.5 mm mini-plug to
mono 3.5 mm mini-plug connector.
When playing back S-VHS recordings, it is recom-
mended to use the S-VIDEO connection to minimize
picture degradation.
TURN ON ALL
COMPONENTS
2
After completing the connections, turn on all the
components.
Set the TV to video input mode or A/V input mode.
Refer to the TV instruction manual.
LOAD CASSETTES
3
Insert the playback cassette into each SR-TS1U.
Set SR-TS1U–2 to "AUX". Press CH 5∞ to select the
input mode depending on the connector being used –
"L-1" for the rear AUDIO/VIDEO IN connector, or "F-
1" for the front AUDIO/VIDEO IN connector.
START PLAYBACK
4
Press PLAY on either of SR-TS1U.
When the playback reaches to the returning position
(tape end or recording end
SR-TS1U successively starts to play. (The cassette will
automatically be rewound when the playback stops.)
Therefore, the cassettes loaded on two SR-TS1U will be
played back alternately as many times as you want.
STOP PLAYBACK
5
Press STOP/EJECT on the SR-TS1U which is playing
back a cassette.
PLAY
JOG
SHATTLE
pg. 28)
pg. 28), the other
To prohibit operations during Series
Playback (Mode Lock)
Press and hold OK on the remote control for more than 5
seconds. The Mode Lock indicator lights up on the front display
panel ( pg. 66). The 2 cassettes will be played back alter-
nately without any interruption.
To resume the other operations, press and hold OK on the
remote control again for more than 5 seconds.
33
EN