Page 1
Fiesta® High Peak Instructions - Supplement to Standard Fiesta Installation Instructions Top of peak adapter Step 1 - Installing Fiesta High Peak Adapter Assembly assembly. High peak casting adapter assembly must be attached to PTT peak casting prior to assembling PTT to frame.
Page 2
Step 2 - Installing Fiesta High Peak Tube High Peak Tube Assembly Assembly cont’d Fabric broken away High peak tube assembly must be installed after spreading for clarity fabric loosely over frame and before raising frame for assembly of uprights, Push the top pin of the high peak tube assembly through the grommet at the peak of the tent fabric.
Page 3
Step 3 - Tensioning Fabric When all of the uprights are raised, attach the snap of the tension straps to the d-rings on the fabric at each upright. At corners, run strap on left side of corner thru the left d-ring and then thru the right d-ring. Run strap on right side thru left d-ring only.
Page 4
Regardless of the number of stakes we suggest, we make no representation or warranty as to whether this speci c number of stakes will meet the local tent code. Anchor does not, nor can it make any suggestions, representation, or warranties about the adequate staking required at each speci c installation site.