Dbs Receiver Brand Setting - JVC HR-VP782U Instructions Manual

48
EN
DBS Receiver
Brand Setting
2
–1 4
CABLE/DBS
1
4
7
1
DBS BRAND NAME
JVC (DISH Network)
ECHOSTAR (DISH Network)
PRIMESTAR
SONY (DSS)
RCA (DSS)
POWER
2
–2
2 3
2
2
5 6
–3
Number
8 9
0
4
2
–4
ENTER
TV CH +/–
BRAND CODE
51
51
50
41
40
MULTI-BRAND REMOTE CONTROL (cont.)
This Remote can control some functions of the DBS
(Direct Broadcast Satellite) receivers listed below.
1
Turn on the DBS receiver
Turn on the DBS receiver using the Power button
on the DBS receiver or its Remote.
2
Enter DBS receiver brand code
Follow the example shown below.
1 Press and hold CABLE/DBS.
2 Press MBR SET.
3 Press the Number keys to enter your DBS
receiver's brand code by referring to the table
below.
4 Press OK, and release CABLE/DBS.
The DBS receiver should turn off. If it does, try
other operations below (
Once you have set the Remote to operate the
DBS receiver, you do not have to set it until you
replace the batteries from the Remote.
3
Operate DBS receiver
While holding down CABLE/DBS, press one of
the following buttons: POWER, TV CH +/–, and
Number keys.
For some brands, you must press ENTER after
having pressed the Number keys to enter a
channel number.
To change the DBS receiver's channels, press
TV CH +/– or the Number keys. (The CH +/–
button can be used to change the VCR's
channels only.)
NOTES:
Depending on the type of DBS receiver, some or all functions
cannot be operated using this Remote.
It's not possible to operate a DBS receiver not equipped with
a remote sensor.
It's not possible to set the Remote for both your DBS receiver
and a cable box at the same time. You can only set the
Remote to operate one of these units at a time.
(Ex.) To set the Remote to JVC 51:
CABLE/ MBR SET
DBS
A/B
Hold
down
step 3).
1
5
Press in succession
Release