2. Set the full-recorded magneto-optical disc with the prevention
erase situation.
3. Press the PLAY key of the remote controller (" T2 EX " changes to
" 1AADJ " on the LCD, adjustment is started.).
4. If it has been finished normally, " 1ADDJ " changes to " 1AOK "
on LCD. If it is abnormally, it changes to " 1ANG ".
5. Press the PLAY key (" 1AOK " or " 1ANG " changes to " T2 EX ",
magneto-optical disc adjusment is finished.).
Note:
If it is displayed " 0ANG ", check the "Troubleshooting Procedures" in the order.
6.2.4. Playback-only disc automatically adjustment
1. Have " T3 EX " indicated on display, and move the optical pickup
to around center (only when a MD cartridge type laser power
meter is used).
2. Set the playback-only disc.
3. Press the PLAY key of the remote controller (" T1 EX " changes to
" 00ADJ " (or " 10ADJ ") on the LCD, adjusment is started.).
4. If it has been finished normally, " 0AADJ " (or " 10ADJ ") changes
to " 00OK " (or " 10OK ") on LCD. If it is abnormally, it changes to
" 00NG " (or " 10NG ").
5. Press the PLAY key [" 00OK " (or " 10OK ") or " 00NG " (or " 10NG
") changes to " T3 EX ", playback-only discadjustment is
finished.]
Note:
If it is displayed " 00NG " (or " 10NG "), check the "Troubleshooting Procedures" in the order.
6.2.5. How to get out the adjustment mode
Remove the battery when you finish the adjustment mode.
6.3. Checking the main unit's keys
1. Set the battery and connect the remote controller.
2. Turn off the power. Then, with the main unit's HOLD switch at
21