Method Of Coping With Shift Lens Error - Sony HDR-CX500 Service Manual

1-4. METHOD OF COPING WITH SHIFT LENS ERROR

Note: The length of low section will vary a little depending on the
conditions.
Change in output voltage of R5653 land on the VC-575 board
1-4-1. E : 62 : 02 [Abnormality of IC for Steadyshot] Occurred
Order
1 Turn the power OFF.
While measuring with an oscilloscope the output voltage of R5653 land in the periphery of IC5501 on the VC-575 board, turn
2
the power ON to check that the output voltage immediately after the power on change as shown in Fig. 2.
If the output voltage change as shown in Fig. 2, replace the lens block (Note). If it does not change as shown in Fig. 2, inspect
3
the camera control circuit (IC7501 of VC-575 board) periphery.
Note: When the lens block was replaced, start the Adjust Manual in the Adjust Station and execute the necessary adjustment
items.
After the adjustment, make sure with the STEADYSHOT turned ON that the steadyshot functions appropriately in the
handheld operation.
HDR-CX500/CX500E/CX500V/CX500VE/CX505VE/
CX520/CX520E/CX520V/CX520VE_L2
VC-575 BOARD (SIDE A)
IC7501
Measurement points on the VC-575 board
about 330 msec
Fig. 2
VC-575 BOARD (SIDE B)
*R5653
*R5653:
No mount (Short land)
Fig. 1
Procedure
1-4
ENGLISH
ENGLISH
IC5501
R5527
JAPANESE
JAPANESE