Table of Contents
Advertisement
28
On-Screen
Timer
Programming
Turn on the TV and select the VCR channel 3 or 4 (or AV
mode).
1
4
NUMBER
7
CANCEL
MENU
When Using The Illumi-Guide Feature
Buttons light or blink on the remote control for
approximately 10 seconds. If the button or buttons extinguish
during timer programming, press ILLUMI GUIDE and the
button or buttons previously lit or blinking come back on. If
the button or buttons do not re-light or start blinking again,
press MENU as many times as necessary to return to the
normal screen and extinguish all illuminated buttons,
and re-perform the timer programming procedure from the
beginning.
If for some reason the remote control's signal is not received
by the VCR, press MENU as many times as necessary to
return to the normal screen and extinguish all
illuminated buttons, and re-perform the timer programming
procedure from the beginning.
™
£
q
3
5/8
2
2
3
5
6
8
9
0
CH
OK
PUSH JOG
ILLUMI GUIDE
TIMER RECORDING (cont.)
You can directly program the VCR's timer to record up to 8
shows, as far as a year in advance. Remember, the clock must
be set before you can program the timer (
Or you can use the Illumi-Guide feature, where the remote
control tells you which button to press next by lighting it up. To
use the Illumi-Guide feature, with the TV/CABLE/VCR switch
set to "VCR", press ILLUMI GUIDE before performing step 2.
(MENU, REW, PLAY, FF light up at this time.)
If you aren't going to use the Illumi-Guide feature, go directly to
step 1.
LOAD A CASSETTE
1
Make sure the record safety tab is intact. If not, cover
the hole with adhesive tape, then load.
The VCR comes on, and the counter is reset,
automatically.
ACCESS ON-SCREEN
MENU
2
Press MENU to bring up the Main Menu screen.
If you are using the Illumi-Guide feature, OK blinks
when the following buttons are lit: NUMBER keys
(0 – 9), PUSH JOG, CANCEL and MENU.
ACCESS PROGRAM SET
SCREEN
3
Make sure the arrow is to
the left of "PROGRAM
SET", then press OK.
If you are using the
Illumi-Guide feature, OK
blinks when the
following buttons are lit:
NUMBER keys (0 – 9),
PUSH JOG, CANCEL and MENU.
SELECT PROGRAM NUMBER
4
Press the appropriate NUMBER keys or CH5 ∞ or
PUSH JOG% fi to select a vacant program number, then
press OK. The first time you do this, all numbers will be
vacant, so just press OK when the screen appears.
If you are using the Illumi-Guide feature, OK blinks
when the following buttons are lit: NUMBER keys
(0 – 9), PUSH JOG, CANCEL and MENU.
pg. 6).
PROGRAM 1
DATE
- - / - -
START
- - : - - AM
STOP
- - : - - AM
CHANNEL
- - SP
PRESS NUMBER KEY(0-9)
OR (5,∞), THEN (OK)
PRESS (MENU) TO END
Advertisement
Table of Contents
