Whirlpool 30" Electric Built-in Single Oven Installation Instructions Manual page 4

Floor Damage
Keep shipping base under
oven when moving across floor.
Failure lo do so may cause
dOmOQe to floor covering.
4
Move oven close to cabinet
. opening. Make the electrical
connection. See "Electrical
requirements' and "Electrical
connection' sections, Panels A
and 8. for details.
5
, Remove and discard the
shipping base. Lift oven up Into
cabinet opening using the oven
opening as an area to grip. Thread
cable through opening in cabinet.
Personal Injury/Product
Damage Hazard
Securely fasten oven to cabinets
using the four screws provided.
Failure to do so could cause the
oven to move or tip during use
and result in personal injury or
prOdUCt damage.
6
Center oven in cabrnet cutout
n
Secure oven to cabinet using
four screws through the mounting
holes in the front frame of the oven
cabinet
7
Put the air grille in place below
. the oven opening, making sure
that the louvers in the air grille point
down. the flange is at the bottom.
and the mounting holes are at the
top. Slide the air grille into position
and attach it to the oven cabinet
with the three, black or chrome
metal screws provided.
8
ReVplace the oven door by
. fktina both corners of the
door over the ends of the hinges.
Push the door evenly and completely
onto the hinges. Remove the nails
from the hinges. Reinstall two screws
In the inner door panel. Close the
oven door. If the door does not
close. YOU have not aushed the
door completely onto the hinges.
9
Turn on power supply. Check
. the operation of the oven
elements. Set the oven selector
control knob to 'BAKE-. Crhe
oven selector control knob is not
available on all models.) Set the
oven temperature control knob to
350°F. The bottom element should
alow red and the indicator light
<hould be on. The upper element
should become hot. but not alow
red. The oven indicator light goes
off when the oven is preheated.
IO
Check the operation of the
. broil element. Set the oven
selector and oven temperature
control knobs to 'BROIL-. (The oven
selector control knob is not available
on all models.) The top element
should glow red and the indicator
light should be on.