Table of Contents
Advertisement
52
Set Stations (A)
Set station names that are registered in your recorder.
Perform steps 1 and 2 of "Storing Channels Manually" on
page 50 to access the Confirmation screen before continuing.
SELECT ITEM
1
@ #
Press %fi
until the item you want begins blinking.
ACCESS MANUAL
CHANNEL SET SCREEN
2
Press OK twice.
SELECT NEW STATION
3
#
Press
until the station
name (ID) begins
blinking, then press %fi
until the new station's
name (ID) you want to
store begins blinking.
Registered station names
(
pg. 53) appear as you
press %fi .
SWITCH STATIONS
4
Press OK.
The Confirmation screen appears.
Repeat steps 1 through 4 as necessary.
CLOSE CONFIRMATION
SCREEN
5
Press MENU.
PR CH
ID
FINE DECODER
06 CH45 – – – – +/–
OFF
[ 5 ∞ ] : CHANGE ID
] : CURSOR +=
[
: OK
[MENU] : EXIT
SUBSIDIARY SETTINGS (cont.)
Set Stations (B)
Set station names other than the ones registered in your
recorder.
Perform steps 1 and 2 of "Storing Channels Manually" on
page 50 to access the Confirmation screen and then
perform steps 1 and 2 of "Set Stations (A)" on the left before
continuing.
SELECT STATION NAME
CHARACTER
1
#
Press
until the first letter
of the station name begins
blinking.
ENTER NEW CHARACTER
2
Press %fi to cycle through the characters (A–Z, 0–9, –,
*
, +,
(space) ) and stop when the desired character
is indicated, then press
characters the same way (maximum of 4).
After entering all characters, press OK.
The Confirmation screen appears.
If you make a mistake, press
character begins blinking. Then enter the correct
character by pressing %fi.
CLOSE CONFIRMATION
SCREEN
3
Press MENU.
PR CH
ID
FINE DECODER
06 CH45 BBC1 +/–
OFF
[ 5 ∞ ] : A-Z, 0-9
] : CURSOR +=
[
: OK
[MENU] : EXIT
#
to enter. Enter the remaining
@
until the incorrect
Advertisement
Table of Contents
