Keypad Lockout; Auto-Dialer Setup; Transmitting Edited Dtmf Tones In The Auto-Dialer Memory; Emergency Alarm - Alinco DR-138 Instruction Manual

6
KEY OPERATIONS
means transmitting frequency higher than receiving frequency.
4. When LCD displays "
means transmitting frequency lower than receiving frequency.
5. Turn Main Dial or Mic's [
frequency in accordance with the step setting.
6.
Press any key except
Under channel mode, this operation can be temporarily available.
Once the radio is turned off or switched to another channel, the
temporary setting will be erased.

KEYPAD LOCKOUT

15 Avoiding unintentional operation, this function will lock, all keys except
and .
、
1.
Press key until LCD displays
icon, then press
displays icon. Now keypad lockout
function is valid.
2.
Repeat above operation,
lockout function is invalid.

Auto-Dialer Setup

This will automatically transmit pre-programmed and stored DTMF tones.
It is necessary to program Auto-dialer tones in advance to operate this
feature.
" icon, it indicates negative offset, which
/ ] key to change offset
and key to set and finish setting.
key until LCD
icon disappears, indicating keypad
1.
While pressing and holding
auto-dialer enquiry mode, LCD displays current default data and
current group displayed on left. If no data in current group, it shows
"EMPTY".
2. Turn selector knob to choose group
you wish to edit. Up to 16 Auto-dialer
memories are available.
3.
Press key to program the DTMF
you wish to transmit automatically.
4.
The display scrolls when the 7th digit
is entered. The numbers 0-9, --, A-D, *
and # can be stored up to a total of 23
digits.
5.
After editing, press PTT
Press to exit and store.

Transmitting Edited DTMF tones in the Auto-dialer memory

1.
While pressing and holding
auto-dialer enquiry
2. Turn Main Dial to select desired auto-dialer group to transmit.
3.
Press PTT to transmit selected DTMF tones.

Emergency Alarm

Under standby state, press and hold
"ALARM", Emergency alarm function is started. This transceiver has 4
Alarm modes for optional, can be setup in programming software. Power
off transceiver to exit Alarm.
key, press key to enter the
key to send current auto-dialer tones.
key, press key to enter into
key until LCD displays