Switching On/Off, Pin Entry - BENQ-SIEMENS EL71 User Manual

Hide thumbs Also See for EL71:
Table of Contents

Advertisement

12

Switching on/off, PIN entry

Operating time
The operating time depends upon
the respective conditions of use.
Extreme temperatures considerably
reduce the phone's standby time.
You should therefore avoid leaving
the phone in the sun or on a radiator.
Talktime: up to 250 minutes
Stand-by time: up to 280 hours
Charge icon not visible
If the battery has been discharged
fully, the charge icon is not immedi-
ately visible when the power supply
is plugged in. It will appear after up
to two hours. In this case the battery
is fully charged after 3 to 4 hours.
Only use the plug-in power supply unit
included in delivery!
Display during operation
Charge level display during
operation (empty–full):
Ý Þ ß
A beep sounds when the battery is
nearly empty. The charge level of the
battery is only displayed correctly
rafter an uninterrupted charging/dis-
charging cycle. You should therefore
not remove the battery unnecessarily
and where possible not terminate the
charging process before completion.
Additional information
The power supply unit heats up when used
for long periods. This is normal and not
dangerous.
If the battery is removed for longer than
30 seconds, the clock must be reset.
Switching on/off,
PIN entry
Switching on/off
B
Press and hold the On/
Off/End key. Press briefly
to open the "Switch off
menu".
Entering the PIN
The SIM card can be protected with
a 4 to 8-digit PIN.
Open slider. Enter the PIN
J
using the number keys.
The characters
pear in the display to en-
sure nobody can read
your PIN. Correct with
Press the left softkey to
§OK§
confirm. Logging on to
the network will take a
few seconds.
ap-
****
]
.

Advertisement

Table of Contents
loading

Table of Contents