Step 3: Installing The Mounting Bracket - Panasonic Over The Range Microwave Oven Installation Instructions Manual

3. Fold the template along a "Rear wall" dotted line. Align the center line with center line on the wall and the
top cabinet. Tape the template to the underneath of top cabinet and the wall. (Fig. 2-3)
3-1 Drill 3 pilot holes at the center point (No.
If Top Exhaust application is chosen, you will need 4 more pilot holes. (No.
If Rear Exhaust application is chosen, you will need 4 more pilot holes. (No.
3-2 Remove the template.
3-3 Drill two / " holes from the No.
1
2
3-4 If Top Exhaust application is chosen, you will need to cut the Top Exhaust opening. (No.
If Rear Exhaust application is chosen, you will need to cut the Rear Exhaust opening. (No.

STEP 3: INSTALLING THE MOUNTING BRACKET

CAUTION:
To support the oven's weight, bracket must be secured by at least
• Four wood screws on the wall studs (2 screws on each side) or
• Two wood screws on the wall studs and 4 toggle bolts through the wall
PREPARATION OF BRACKET ASSEMBLY
Note: If Rear Exhaust is chosen, the product need a Rear Wall Exhaust cutout opening for the Rear Wall duct
and the Exhaust adaptor must be installed on the bracket (hardware item
(hardware item
Check that the damper blade moves smoothly and opens fully as shown. (Fig. 3-1)
IP2386_38Q01CP_Eng_04_080105.indd 10 IP2386_38Q01CP_Eng_04_080105.indd 10
Template
Tape
pilot holes. Drill a 1
q
) (Fig. 2-1).
t
Taping
Center Line
Center Line of Wall
Fig. 2-3
and No. in Fig. 2-1)
q w
/ " hole from the No.
3
16
Damper Blade
Opens Fully
Exhaust
Damper
Mounting Screws
Fig. 3-1
10
in Fig. 2-1)
e
in Fig. 2-1)
r
pilot hole for AC cord.
w
in Fig. 2-1)
t
in Fig. 2-1)
y
) with two screws.
y
2009-1-6 Michael 9:16:49 2009-1-6 Michael 9:16:49