Connecting The Satellite (Front, Center, Surround) Speakers - JVC TH-C40 Instructions Manual

Connections
Connecting the satellite (front,
center, surround) speakers
7 Assembling the speakers —
7 For TH-C60: Assemble front speakers and surround speakers.
7 For TH-C50: Assemble front speakers.
For the surround speakers of TH-C50, see "Connecting the
surround speakers — TH-C50". (See page 10.)
For TH-C60
Front speaker Surround
(SP-THC60F) (2) speaker
(SP-THC60S) (2)
• Check the model name of each speaker from the label on the
rear to locate each speaker correctly.
For TH-C50
Front speaker
(SP-THC60F)(2)
Assembled speakers
With stand: Refer to steps 1 to
3.
Do not connect the power cord until all other connections have been made.
TH-C60/TH-C50
Base plate (4)
Stand (4)
Stand (2) Base plate (2)
or
Without stand: Refer to steps
2 and 3.
Before assembling —
• Prepare a Phillips screwdriver (not supplied).
• Take care not to drop any component part while assembling;
otherwise, it may cause damage to the floor or injury.
When assembling a speaker without stand:
Speaker
Stand (or speaker
directly)*
* When assembling the speaker with the base plate, use the
screws A .
Red
Black
Speaker
Stand
Screw M5 x 40 mm/M5 x 1-5/8
inches (supplied)
A: Use these screws (M4 x
45 mm/M4 x 1-13/16 inches)
when assembling the speaker
with the base plate.
Base plate
Screw M4 x 20 mm/M4
x 13/16 inches
(supplied)*
White
Black
You can route the speaker cord
by using speaker cord clamp
(supplied).