Panasonic Viera TH-P42GT20D Operating Instructions Manual page 75

FAQs
Sound is unusual
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
Cannot connect to the
network
Cannot select the file
during DLNA operations
Cannot operate
VIERA CAST
Cannot see 3D images
3D Eyewear is turned off
automatically
There is something wrong
with the 3D images
TV goes into Standby
mode
The remote control does
not work or is intermittent
Parts of the TV become hot
74
Problem
●
Set the sound setting of the connected equipment to "2ch
L.PCM".
●
Check the "HDMI1 / 2 / 3 / 4 Input" setting in the Sound
Menu. (p. 32)
●
If digital sound connection has a problem, select analogue
sound connection. (p. 68)
●
Is the HDMI cable connected properly? (p. 59, 64 and p. 65)
●
Turn Off the TV and equipment, then turn them On again.
●
Check an input signal from the equipment. (p. 69)
●
Use an equipment compliant with EIA/CEA-861/861B.
●
Check the LAN cable or Wireless LAN Adaptor is connected
properly. (p. 50)
●
Check the connections and settings. (p. 50 - 53)
●
Check the network equipment and network environment.
●
If the problem persists, consult your Internet Service Provider
or telecommunications company.
●
Is media server prepared? (p. 49)
●
Check applicable data format. (p. 49)
●
Check the connections and settings. (p. 50 - 53)
●
The server or connected line might be busy now.
●
Has the 3D Eyewear been switched On?
●
Ensure that "3D Picture Display" in "3D Settings" is set to
"3D". (p. 26)
●
Some 3D image signals may not be automatically recognized
as 3D images. Set "3D Picture Format" in "3D Settings" to
match the picture format. (p. 26)
●
Check that there are no obstacles between the infrared
sensors on the TV and the 3D Eyewear. If the 3D Eyewear
stops receiving the infrared signal for about 5 minutes, the 3D
Eyewear will be turned off automatically.
●
Check the available area to use the 3D Eyewear. (p. 24)
●
Depending on the person, the 3D images may be difficult
to see, or cannot be seen, especially in users that have a
different level of eyesight between the left and right eyes.
Take the necessary steps (wearing glasses etc.) to correct
your eyesight before use.
●
Check that there are no obstacles between the infrared
sensors on the TV and the 3D Eyewear or that the 3D
Eyewear is placed inside the coverage area (p. 24). If the
3D Eyewear stops receiving the infrared signal for about 5
minutes, the 3D Eyewear will be turned off automatically.
●
Check the setting of "3D Picture Sequence" or "Edge
Smoother". (p. 26)
●
Auto power standby function is activated.
●
The TV enters Standby mode about 30 mins. after analogue
broadcasting ends.
●
Are the batteries installed correctly? (p. 3)
●
Has the TV been switched On?
●
Point the remote control directly at the front of the TV (within
about 7 m and a 30 degree angle of the front of the TV).
●
Situate the TV away from sunshine or other sources of
bright light not to shine on the TV's remote control signal
receiver.
●
Even when the temperature of parts of the front, top and
rear panels has risen, these temperature rises will not pose
any problems in terms of performance or quality.
Actions