HP 5400zl Series Installation And Getting Started Manual page 44

Installing the Series 5400zl Switches
Installation Procedures
8 mm
M4 screws
Figure 2-7. Attaching Brackets to the 5400zl Switch
2.
Partially install a screw
into the top hole of a
close (0.5-inch) pair on
both sides of the rack
Figure 2-8. Mounting Screw Positioning
3.
2-18
Partially install a screw into the top hole of a pair of holes that are 0.5
inches apart in each rack/cabinet upright as shown in the illustration
below. Ensure that the screws are at the same level in each upright.
Place the switch in the rack and lower it so the notches in the bottom of
the bracket slide onto the screws, then tighten these screws.