Sony MDS-JE480 Service Manual page 23

QQ
3 7 63 1515 0
4-6. FUNCTIONS OF OTHER BUTTONS
Function
G
x
M
m
REC MODE
PLAY MODE
LEVEL/DISPLAY/CHAR
A
REPEAT
4-7. TEST MODE DISPLAYS
Each time the LEVEL/DISPLAY/CHAR button is pressed, the display changes in the following order.
When CPLAY and CREC are started, the display will forcibly be switched to the error rate display as the initial mode.
1. Mode display
Displays "TEMP ADJUST", "CPLAY1MODE", etc.
2. Error rate display
Displays the error rate in the following way.
C = AD =
C = Indicates the C error.
AD = Indicates ADER.
TE
L 13942296513
3. Address display
The address is displayed as follows. (MO:recordable disc, CD:playback only disc)
If the REC MODE button is pressed , the display switches from groove to pit or
vice versa.
h = s =
h = a =
h = Indicates the header address.
s = Indicates the SUBQ address.
a = Indicates the ADIP address.
Note: "–" is displayed when the address cannnot be read.
www
.
http://www.xiaoyu163.com
Sets continuous playback when pressed in the STOP state. When pressed during continuous
playback, the tracking servo turns ON/OFF.
Stops continuous playback and continuous recording.
The sled moves to the outer circumference only when this is pressed.
The sled moves to the inner circumference only when this is pressed.
Switches between the pit and groove modes when pressed.
Switches the spindle servo mode (CLV S y CLV A).
Switches the displayed contents each time the button is pressed.
Ejects the disc.
Exits the test mode.
(MO pit and CD)
(MO groove)
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Contents
Q Q
3 6 7 1 3 1 5
co
.
MDS-JE480
9 4 2 8
Mode display
Error rate display
Address display
Auto gain display (Not used in servicing)
0 5 8 2 9 9 4 2 8
Detrack check display (Not used in servicing)
IVR display (Not used in servicing)
C1 error and Jitter display
(Not used in servicing)
AD error and Jitter display
(Not used in servicing)
m
9 9
9 9
23