Troubleshooting - JVC LVT0027-005A Instructions Manual

Troubleshooting

• If you are having a problem with your System, check this list for a possible solution before calling for service.
• If you cannot solve the problem from the hints given here, or the System has been physically damaged, call a qualified person, such as your
dealer, for service.
Symptom
No sound is heard.
Unable to record.
Poor radio reception
The CD skips.
The CD does not play.
Unable to operate the Remote Control.
Operations are disabled.
The cassette door cannot be opened.
Possible Cause
• Connections are incorrect, or loose.
• Headphones are connected.
Cassette record protect tabs are removed.
• The antenna is disconnected.
• The AM Loop Antenna is too close
to the Unit.
• The FM Wire Antenna is not prop-
erly extended and positioned.
The CD is dirty or scratched.
The CD is upside down.
• The path between the Remote Con-
trol and the sensor on the Unit is
blocked.
• The batteries have lost their charge.
The built-in microprocessor has mal-
functioned due to external electrical
interference.
During tape playing, the power cord was
unplugged.
Action
• Check all connections and make cor-
rections. (See pages 4 - 5.)
• Disconnect the headphones.
Cover the holes on the back edge of the
cassette with tape.
• Reconnect the antenna securely.
• Change the position and direction of
the AM Loop Antenna.
• Extend FM Wire Antenna to the best
reception position.
Clean or replace the CD.
Put the CD in with the label side up.
• Remove the obstruction.
• Replace the batteries.
Unplug the Unit then plug it back in.
Plug in the power cord, press the
button, and then press the 0 button.
19