Table of Contents
Advertisement
Tomcat i875P S5102
IDE HDD Block Mode:
Leave this setting as is.
Enabled / Disabled
On-Chip Primary PCI IDE:
The integrated peripheral controller contains an IDE interface with support for two IDE
channels. Select "Enabled" to activate each channel separately.
Enabled / Disabled
Primary / Secondary Master/ Slave PIO:
The four IDE PIO (Programmed Input / Output) field let you set a PIO mode (0-4) for each of
the four IDE devices that the onboard IDE interface supports. Modes 0 through 4 provide
successively increased performance. In Auto mode, the system automatically determines the
best mode for each device.
Auto / Mode 0 / Mode 1 / Mode 2 / Mode 3 / Mode 4
Primary / Secondary Master/ Slave UDMA:
This allows you to select the mode of operation for the Ultra DMA/33 implementation is
possible only if your IDE hard drive supports it and the operating environment includes a DMA
driver (Windows 95 OSR2 or a third-party IDE bus master driver). If your hard drive and your
system software both support Ultra DMA/33, select Auto to enable bios SUPPORT.
Auto / Disabled
On-Chip Serial ATA:
The integrated peripheral controller contains a SATA interface with support for two SATA
channels. Select "Enabled" to activate each channel separately.
Enhanced Mode / SATA Only
Serial ATA Port 0/1 Mode:
This item allows you to set SATA mode.
Primary Master / Primary Slave / Secondary Master / Secondary Slave
Onboard Device:
USB Controller
USB 2.0 Controller
USB Keyboard Support
USB Mouse Support
Onborad Promise Raid Ctrl
CSA LAN (Giga-LAN)
↑↓←→: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Phoenix – AwardBIOS CMOS Setup Utility
Onboard Device
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Enabled]
[Enabled]
3-13
http://www.tyan.com
Chapter 3: BIOS Setup
Item Help
_________________________
Menu Level ? ?
Advertisement
Table of Contents
