Advertisement
Quick Links
Cobalt HVLP
Siphon/Pressure Feed Spray Gun
Important Safety Instructions
Read all warnings and instructions in this manual.
Save these instructions.
Maximum Air and Fluid Inlet Pressure:100 psi (0.7 MPa, 7 bar)
Maximum HVLP Compliant Air Pressure:
Part No. 5860, 5862, 5863, 5864, 5865 - 50 psi (345 kPa, 3.4 bar)
Part No. 5866 - 40 psi (276 kPa, 2.8 bar)
II 2 G
SHARPE MANUFACTURING COMPANY • P.O. BOX 1441, MINNEAPOLIS, MN 55440-1441
1-800- 742-7731, www.sharpe1.com
310799B, 4/2006
THE SPRAY GUN PEOPLE
FOR PRODUCT INFORMATION CALL:
1-800-742-7731
Advertisement
Related Manuals for Sharpe Cobalt HVLP
Summary of Contents for Sharpe Cobalt HVLP
- Page 1 Part No. 5860, 5862, 5863, 5864, 5865 - 50 psi (345 kPa, 3.4 bar) Part No. 5866 - 40 psi (276 kPa, 2.8 bar) II 2 G SHARPE MANUFACTURING COMPANY • P.O. BOX 1441, MINNEAPOLIS, MN 55440-1441 1-800- 742-7731, www.sharpe1.com 310799B, 4/2006...
-
Page 2: Year Limited Warranty
Check hoses, tubes, and couplings daily. Replace worn or damaged parts immediately. 2 Year Limited Warranty Sharpe warrants this product to the original user against defective material or workmanship for a period of 1 year from the date of purchase. -
Page 3: Operation
If an air adjusting valve is possible pressure. desired, use a SHARPE Air Adjusting Valve 24AAV (part no. 2210), 36AAV-HOV (part no. 3310) or HOV (part no. Refer to Compliant Cleaning Methods, page 4, to com- U04410). -
Page 4: Cleaning And Maintenance
COBALT HVLP SIPHON/PRESSURE FEED SPRAY GUN Cleaning and Maintenance Cleaning Nozzle and Air Cap CAUTION • Trigger gun and use nozzle removal tool 41160 whenever WARNING you tighten or remove nozzle to avoid damaging needle seat and nozzle. • Do not use metal tools to clean air cap holes as this may Follow Pressure Relief Procedure when you stop spraying scratch them and distort the spray pattern. -
Page 5: Troubleshooting
COBALT HVLP SIPHON/PRESSURE FEED SPRAY GUN Troubleshooting WARNING Follow Pressure Relief Procedure, page 3, before troubleshooting or servicing. Read warnings, page 2. Problem Cause Solution Normal pattern No action necessary Right Dirty or damaged air cap or fluid nozzle. Rotate air cap 180°. - Page 6 1.4 mm 27001 118536 26065 Control Valve/Knob 5865 1.8 mm 27001 118537 41137 Screw Air Cap 5866 2.2 mm 27003 118538 table 16100 Nozzle Gasket SHARPE MANUFACTURING COMPANY • P.O. BOX 1441, MINNEAPOLIS, MN 55440-1441 1-800- 742-7731, www.sharpe1.com 310799B, 4/2006...