Yamaha F50F Service Manual page 60

CHK
ADJ
3. Loosen the locknut 1, and then adjust
the throttle link rod length a.
a
1
Throttle link rod length a:
121 mm (4.76 in)
4. Align the alignment mark b on the throt-
tle control lever with the alignment mark
c on the bracket.
c
5. Connect the throttle link rod to the throttle
body.
NOTE:
Connect the end of the throttle link rod that
does not have a locknut to the throttle body.
3-11
Periodic checks and adjustments
S6C13120
c
b
b
S6C13130
6. Contact the cam roller 2 on the throttle
control lever to the throttle cam as
shown, and then adjust the position of
the throttle link rod until the joint 3 of the
throttle link rod is aligned with the joint 4
of the control lever.
2
3
7. Connect the throttle link rod to the throttle
link, and then tighten the locknut.
8. Loosen the locknut 5, remove the clip
6, and then disconnect the throttle cable
joint 7.
9. Adjust the throttle cam 8 until the align-
ment mark d on the throttle cam is
aligned with the alignment mark e on
the bracket.
S6C13140
4
S6C13150
5
6
7
S6C13160
6C13G11