Pppoe (Username/Password) - D-Link DIR-524 User Manual

Section 4 – Security
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide
you with a username and password. This option is typically used for DSL services. Make sure to remove your PPPoE
software from your computer. The software is no longer needed and will not work through a router.
PPPoE Enter your PPPoE user name.
UserName:
PPPoE Enter your PPPoE password and then retype
Password: the password in the next box.
PPPoE Service Enter the ISP Service Name (optional).
Name:
Idle Time: Enter a maximum idle time during which the
Internet connection is maintained during
inactivity. To disable this feature, enable
Auto-reconnect.
MTU: Maximum Transmission Unit - you may need
to change the MTU for optimal performance
with your specific ISP. 1492 is the default
MTU.
MAC Address: The default MAC Address is set to the
Internet
address on the Broadband Router. It is not
recommended that you change the default
MAC address unless required by your ISP.
You can use the Clone MAC Address button
to replace the Internet port's MAC address
with the MAC address of your Ethernet card.
————————————————————————————————————————————————————————————
D-Link DIR-524 User Manual

PPPoE (username/password)

port's physical interface MAC
20