Korg Oasys Operation Manual page 144

Sampling (Open Sampling System)
When the power is first turned on, the assigned
sample will be set to "Orig.Key C2.
2. Make the following settings.
– INPUT1 –
Bus Select (IFX/Indiv.): Off
Turn off the input from the INPUT 1–4 and S/P DIF
L/R jacks.
– Sampling Setup –
Source Bus: L/R
The sound sent to the L/R will be sampled.
Trigger: Sampling START SW
After you've pressed the SAMPLING REC switch
to enter sampling‐ready mode, resampling will
begin when you press the SAMPLING
START/STOP switch.
Resample: Auto
The sample assigned to the index will be resampled
automatically.
Key: C2
Use Key to specify the sample that will be
resampled.
Recording Level: 0.0
This is the default setting for resampling.
Save to: RAM
The data will be written to RAM memory.
Sampling Mode: Stereo
The sound of the internal L/R channels will be
sampled in stereo.
Auto +12dB On: On
The +12 dB setting will automatically be turned on
for the samples you record.
Be aware that if you change the Bus setting from Off
to L/R or IFX1–12, the volume level sent to the
AUDIO OUT L/MONO and R jacks and the
headphones may rise excessively.
136
3. In P2: Loop Edit, check the +12 dB setting.
4. In the P8: Insert Effect– Routing page, set Bus
Select to IFX1.
5. In the P8: Insert Effect, Insert FX page, set IFX1 to
101: Reverb Hall, and turn IFX On/Off ON.