Minolta MACRO TWIN FLASH 2400 Instruction Manual page 11

ATTACHING THE TWIN FLASH
You can use an arm to position the flash
unit away from the lens.
Attach the arm by sliding its base into
one of the four shoes on the holder.
60° position 90° position
• In order to prevent breakage, it is possible to move the arm past the
two correct stop positions. However, to prevent excessive wear, use
only in the correct positions.
• It is also possible to attach the two arms in tandem, but this is not rec-
ommended as the excesive length could result in breakage.
20
The arm can be set
at either of two
lengths.
The angle of the arm can be
adjusted to either of two
positions. The arm is secured in
each position by a double click
stop.
The cord reel can be attached to the side of the controller to take
up excessive cord slack.
When attaching it to the controller, orient
the reel with the Minolta logo in a
readable horizontal position, and place
the top of the reel's center cut-out over
the top of the three protruding pins on
the controller. Next, rotate the reel down
until the reel's center cut-out clicks into
place over the lower protruding pins.
To remove the reel, rotate the bottom of
the reel away from the controller and
remove.
Secure the excess cord
by wrapping it around the
reel and using the outer
cut-outs as shown in the
illustration.
21