F-Louver Ass'y (Sj-A31S/A34S) - Sharp SJ-A20S-SL Service Manual

6-$6%6$6%6$6%6$6$6

[2] F-LOUVER ASS'Y (SJ-A31S/A34S)

1. Fan motor ass'y
1. Stick U-sealer handle to Fan motor holder a (Fig. A-2).
2. Insert the terminal of Lead EV-cover to Fan motor (Fig. A-3).
3. Insert shaft of Fan motor to the hole of motor cushion, set at Fan motor holder a.
Next, insert the boss of rear to the hole of Motor cushion, set at fan motor b.
Then fix with Tapping screw (2 pieces).
4. Set Fan clamp to propeller fan 100 mm. and then insert it to the shaft of Fan motor( Fig. A-4).
Fan motor holder a
U-sealer handle
WIRE COLOR IS GRAY/ORANGE
(127V : with yellow tape)
Lead EV-cover
Note
(1) Assemble so that terminal of Fan motor does not deform.
(2) Take care not to stress to terminals of Fan motor after wiring.
(3) Check locking by pulling them with more than 10N(1 kgf).
Motor cushion
U-sealer handle
Fan motor holder a
Fan clamp
Propeller fan 100
Fan motor holder a
U-sealer handle
SEC. C-C
Figure A-2
Fan motor
Figure A-3
Fan motor holder b
Tapping screw
Motor cushion
Fan motor
Slit area
U-sealer handle
Lead EV-cover
BROWN
Figure A-1
Propeller fan 100
Fan clamp
Fan clamp
Propeller fan 100
NO GOOD
GOOD
Note
(1) Slit of each Fan Clamp and propeller fan 100 should not be at same
position.
(2) Fan clamp should be inserted virtically to the end of boss.
(3) Propeller fan should not be taken out from shaft when pulled by 2 kgf.
8 – 4
Tapping screw
RED
Detail of D
Fan motor holder a
Fan motor holder b
Motor cushion
Motor cushion
Fan motor
slit
Fan clamp
slit
Figure A-4