Sony Cyber-Shot DSC-HX200 Instruction Manual page 26

ND Filter
Metering Mode
Cont. Shooting
Interval
Bracket Setting
Scene Recognition
Soft Skin Effect
Smile Shutter
Smile Detection
Sensitivity
Face Detection
Flash Level
Color Mode
Color Saturation
Contrast
Sharpness
Noise Reduction
Anti Blink
Movie SteadyShot
Position
Information*
GPS Log REC*
Register Setting
GB
26
Turn the internal ND filter on or off.
Select the metering mode that sets which part of the
subject to measure to determine the exposure.
Select the number of images taken per second for Burst
shooting.
Set the type of the bracket shooting.
Set to automatically detect shooting conditions.
Set the Soft Skin Effect and the effect level.
Set to the camera automatically release the shutter when
a smile is detected.
Set the Smile Shutter function sensitivity for detecting
smiles.
Select to detect faces and adjust various settings
automatically.
Adjust the amount of flash light.
Select the vividness of the image, accompanied by
effects.
Adjust the vividness of the image.
Adjust the contrast of the image.
Adjust the sharpness of the image.
Adjust the image resolution and the noise balance.
Set to automatically shoot two images and select image
in which the eyes are not blinking.
Set the strength of SteadyShot in Movie Mode. If you
change the setting for [Movie SteadyShot], the angle of
view will change.
Check the GPS triangulating status and update the
position information.
Record the route taken while carrying the camera.
Register the desired modes or camera settings. Set the
mode dial to (Memory recall mode) to retrieve the
registered settings.