Table of Contents
Advertisement
effective way to produce a normal Fade In (crescendo), or
Fade Out (decrescendo) effect.
fig.11-08e
Fade In (crescendo)
/Fade Out (decrescendo) effect
Phrase
about 5 sec
When you use the Stop button (or other means) to stop a
phrase during playback for which this setting has been made,
the phrase stops with a Fade Out. If you don't want a Fade
Out, pressing the Stop button again stops the phrase
immediately.
Procedure for Making the Settings for Fade In
or Fade Out
1. Use the SELECT dial to choose the phrase whose setting
you want to change.
2. Press the MODE button.
The MODE indicator lights up.
3. Use the SELECT dial to choose "1.6 Fade," then press the
dial.
You can reselect a phrase whose setting you want to change
by pressing the PAUSE (BACK) button. The entry position
(highlighted) moves to the phrase selection, so turn the
SELECT dial to reselect card A or B and the phrase number,
then press the dial.
4. Turn the SELECT dial to make the setting for Fade In
(time: OFF, Time 1 to Time 3, or from 00.1 to 59.9
seconds), then press the dial.
fig.11-g06e
Turn the SELECT dial to make the setting for Fade Out (time:
OFF, Time 1 to Time 3, or from 00.1 to 59.9 seconds), then
press the dial.
5. When the prompt appears on the screen, press the
ENTER button to enable the settings.
To quit without making the setting, use the SELECT dial to
choose "NO," then press the ENTER button.
Once the settings have been successfully modified, you're
returned to the setting item selection screen.
6. Press the MODE button.
This ends the setting process and returns you to the usual
screen.
* While making the settings, you can go back to the previous
Modifying Recorded Phrases (Phrase Settings)
about 5 sec
entry location (highlighted) by pressing the PAUSE (BACK)
button.
* If you press the MODE button while making settings, a
message asking you to confirm that you want to exit the
setting process appears. Note that if you choose "YES," then
press the ENTER button, you are returned to the usual screen,
and all setting changes you've made up to that point will be
discarded.
Fade settings may not be properly reflected in situations such
as the following:
• When the set fade time is longer than the phrase.
• When fade-in and fade-out settings overlap.
• When loop-interval settings and fade settings overlap.
Control Out
This makes the setting for Control Out operation after phrase
playback ends.
For detailed information on how to use Control Out, refer to
"Controlling Another Device with the AR-3000 (Control
Output Terminal)" (p. 102).
Procedure for Making the Control Out Settings
1. Use the SELECT dial to choose the phrase whose setting
you want to change.
2. Press the MODE button.
The MODE indicator lights up.
3. Use the SELECT dial to choose "1.7 Control Out," then
press the dial.
You can reselect a phrase whose setting you want to change
by pressing the PAUSE (BACK) button. The entry position
(highlighted) moves to the phrase selection, so turn the
SELECT dial to reselect card A or B and the phrase number,
then press the dial.
4. Turn the SELECT dial to choose Control Out (OFF or
ON), then press the dial.
fig.11-g07e
Turn the SELECT dial to set the Offset Time (from 00m00s to
59m59s), then press the dial.
* The offset time can be set only when Control Out "ON" is
59
Advertisement
Table of Contents
