Operation And Settings; Projecting Image - JVC DLA-SH4KNL Instructions Manual

Operation and Settings

Projecting Image

If setting for this projector is not completed, refer to the
"Setting Menu" (A Page 24) upon turning on the power
and configure the settings accordingly.
Once the basic settings are configured, this projector can
be used by simply performing the following operation
procedures.
PREPARATION:
● Remove the lens cap.
● Connect this projector to the computer. (A Page 17, 19)
● Connect the LAN cable. (A Page 20)
1
Set this projector to the standby mode, and
display the main menu
● Refer to "Configuring the Network Settings".
(A Page 20)
● The [STANDBY/ON] indicator lights up in red.
2
Click the AONB button under the APowerB item
of the main menu to project the image
● The power of this projector turns on, and the
projected image appears.
● The [STANDBY/ON] indicator lights up in green.
Power
Main
Image
ON OFF
Setting
Signal Status
Convergence
DVI Rate(Hz) Pixel H
Lens
1 60.00 2048
Option
2
Network
3 60.00 2048
Mail
4
Projector Usage
Lamp Time
NOTE:
● You can also turn on the power by pressing the
[OPERATE I/B] button on the projector unit for more
than one second.
● The image may flicker for a few seconds immediately
after projection starts. This is not a malfunction.
● After the lamp lights up, it takes about 1 minute or
longer for the brightness of the video image on the
screen to stabilize.
22
host PJ-1
user: root
Logout
Latest Error
STANDBY 00
Temperature
Pixel V Link
Temp. 1
2400 Dual
36.0 deg.C
Temp. 2
2400 Dual
25.5 deg.C
1035h24m
Reset
3
Adjust the zoom ratio (screen size)
You can adjust the focus using the AZoomB item of the
Lens menu.
Zoom Focus
Main
w +
Image
Setting
Convergence
Lens
Option _
Network
T
Mail
To enlarge the screen size:
Press the AWB (Wide) end of AZoomB
To reduce the screen size:
Press the ATB (Tele) end of "Zoom"
NOTE:
● The screen size changes each time you click on the
inner buttons ( / ). (Fine control)
The outer buttons ( / ) change the screen size when
they are depressed. (Coarse control)
4
Adjust the position of the projection screen
You can adjust the focus using the AShiftB item of the
Lens menu.
To shift the image upward:
Press the AUB end of AShiftB
To shift the image downward:
Press the ADB end of AShiftB
To shift the image rightward:
Press the ARB end of AShiftB
To shift the image leftward:
Press the ALB end of AShiftB
NOTE:
● The adjustment range for lens shift is between 0 %
and ±50 % in the vertical direction, and between 0 %
and ±25 % in the horizontal direction (during single-
screen display).
● The position changes each time you click on the inner
buttons ( / ). (Fine control)
The image shifts when the outer buttons ( / ) are
depressed. (Coarse control)
host PJ-1
user: root
Logout
Shift
U
L R
D