No Sound - Sanyo PLC-WXU30A Service Manual
Sanyo multimedia projector service manual
Hide thumbs
Also See for PLC-WXU30A:
- Owner's manual (82 pages) ,
- Owner's manual (13 pages) ,
- Specification sheet (1 page)
Table of Contents
Advertisement
troubleshooting
No Sound
Check following steps.
Check if the audio sig-
nal is observed at pins 7
and 15 of IC5001.
Yes
Check if the audio sig-
nal is observed at pins 5
and 8 of IC5031.
Yes
Check audio output circuit.
Check speaker, connection of the terminal "K8F"
No
Check IC5001 and peripheral circuit.
Check 5V_AUDIO, 1V power supply.
No
Check IC5031, 5V_AUDIO and peripheral circuit.
Check the Mute signal at pin 1 of IC5031. The Mute signal is output from
pin 9 of IC 301<Scaler>. The OUT_DET signal is sent from Audio Out
terminal.
Mute-On: H at pin 347 of IC301, L at pin1 of IC5031
-61-
Advertisement
Table of Contents
