NEC SL1000 Programming Manual page 278

SL1000/SL1100
Item No.
02
03
04
Program
05
22
06
07
08
09
11
Default
The default value of Programs 22-11-01 and 22-11-02 is shown as below.
Conversion Table
2-256
Input Data
Target Number
Enter the destination number to
which the DID number is sent.
DID Name
This is the name that is assigned to
the DID digits when it rings the ex-
tension.
Transfer Operation Mode
Transfer Destination Number 1
Transfer Destination Number 2
400 - Allow the outside party to dial a
different extension number in the
translation table (for example, ring no
answer to a dialed number, the caller
then hears a dial tone, allowing them
to enter another Valid Extension
Number).
401 - Provide the caller with DISA
dialing options (requires using the
DISA password).
This applies to 22-11-05
and 22-11-06.
Call Waiting
Program 20-09-07 overrides this set-
ting.
Maximum Number of DID Calls
Music on Hold Source
Incoming Ring Group Transfer
Enable (1) or disable (0) each con-
versation tables ability to follow the
Ring Group programming defined in
Program 22-12-01 : DID Intercept
Ring Group.
If Program 22-11-05 : DID Transla-
tion Number Conversion, Transfer
Destination Number 1 and Program
22-11-06 : DID Translation Number
Conversion, Transfer Destination
Number 2 are set, the priority of
transferring is in this order: Program
22-11-05 then Program 22-11-06
then if Program 22-11-11 is enabled,
Program 22-12-01.
If the terminal is in Power
Cutting mode from the ecol-
ogy feature this command
will not be applied.
1
2
Description
Maximum 36 digits
(0 ~ 9, , #, @)
*
Maximum 12 characters
0 = No Transfer
1 = Busy
2 = No Answer
3 = Busy/No Answer
0 = No set
01 ~ 25 = Incoming Ring Group
102 = VMI
201 ~ 232 = Department Group
400 = DUD
401 = DISA
501 ~ 599 = DISA
(VRS Message No.)
1000 ~ 1999 =
Common ABB Dial (000 ~ 999)
0 = Disable (No)
1 = Enable (Yes)
0 ~ 126 (0 = No limit) (SL1000)
0 ~ 096 (0 = No limit) (SL1100)
0 = IC/MOH Port
1 = BGM Port
0 = Disable (Caller will hear Ringback)
1 = Enabled (Go to normal ring)
Received number
00
01
Program 22 : Incoming Call Setup
ISSUE 1.0
Default
See Default Value
No setting
0
0
0
0
0
0
1
Target number
200
201