Control Operation; First Use - U-Line 1000 Series Quick Start Manual

QUICK START GUIDE

Control Operation

CONTROL FUNCTION GUIDE
FUNCTION
ON/OFF
Toggle lights
Adjust temperature
View temperature in unit
Toggle between F/C

First Use

All U-Line controls are preset at the factory. Initial startup
requires no adjustments.
NOTICE
U-Line recommends allowing the unit to run
overnight before loading with product.
1200 SERIES
When plugged in, the unit will begin operating under the
factory default settings. If the unit was turned off during
installation, simply press
switch on. To turn the unit off, press
Up Down
COMMAND
Press and release
Press and release to leave interior
light on for 3 hours
Press and release
or
Press together and release
and
Hold and for five seconds
and the unit will immediately
.
Light Power
DISPLAY/OPTIONS
Unit will immediately turn ON or OFF.
Glass door wine and beverage centers only.
When the "F" or "C" in the display is flashing, press
or to adjust the set point temperature.
The display will flash and then toggle from set point
to temperature in unit.
The display will change units.
1024BEV
MECHANICAL DIAL CONTROL
The control dial turns unit ON/OFF and sets temperature.
This set point temperature is a base setting used by the
controller to maintain the temperature zone in the unit.
The factory default MID setting, number 4 set point is
approximately 38°F (3°C). The set point temperature is a
gauge for further temperature adjustments.
5
u-line.com
Not Alert
Used LED