Advertisement
General Information
1.0 Safety Precautions
Model 335 Supplement
The Series 300 Operator's Manual and Service Manual provide
information on installation, checkout and maintenance for all
Series 300 projectors including the Model 335. There are some
distinct areas with reference to the Model 335, mainly due to the
larger Xenon Arc Lamp, that require additional information and
procedures. Focusing on these distinct areas and special
procedures is the purpose of this supplement.
The areas discussed in this supplement are:
1.0 Safety precautions: Any necessary safety precautions that
are characteristic to the Model 335 Projector that were not
referred to in the Series 300 Operator's Manual or Service
Manual.
2.0 External Arc Lamp Power Supply: Provides the additional
power required for the larger 2500 watt Xenon Arc Lamp.
NOTE: Model 335 Projectors with serial numbers 351100 or
higher will not require an external power supply. The additional
current required by the larger arc lamp is supplied by the system
power supply itself. Refer to the Series 300 Service Manual.
3.0 Brightness Level Checks: Additional procedures required
for adjustments that may be necessary on the arc lamp and
external power supply if low brightness levels are encountered.
4.0 Electronics Module Removal and Replacement: A separate
procedure is included for the Model 335 for the removal and
replacement of the Electronics module.
5.0 Lamphouse and Ignitor Removal and Replacement: A
separate procedure is included for the Model 335 for the removal
and replacement of the Lamphouse Assembly or Ignitor Assembly.
All safety precautions mentioned in the Series 300 Operator's
Manual are applicable and should be reviewed prior to operating
or adjusting the Model 335.
4
Advertisement
