Advertisement
Basic Play
The illustration of the grip band is omitted.
Follow the steps in the numerical order.
R
L
HBS
2
1
Firmly connect
5
9
6
VOLUME
VOLUME
VOLUME
VOLUME
Operation
Button
During play,
To pause
Press again to restart play.
During play,
Total number of tracks
To stop
While stopped,
No indication
To turn off the
unit
Skip function
• To skip back to the previous track, quickly press 4
During play,
twice.
Forward
• During Program play, the button is used to fast for-
ward or back through the programmed sequence of
Fast forward/
0
tracks.
reverse
Reverse
• During Random play, the skip button cannot be used
to skip back to tracks that were played previously in
the random sequence.
Search function
Keep depressed during play.
During play or while stopped,
PRESET UP
Forward
Group skip
GROUP
(MP3 only)
Reverse
PRESET DOWN
5
Other Play Methods
Intro play
Program play
You can successively play the first 10 seconds of every track.
You can program up to 64 tracks in any desired order including
the same tracks.
1
For Audio CD, go to step 3.
While stopped,
Though the display differs a little, operation is the same.
1
MODE
While stopped,
(MP3 only)
PROGRAM
(Repeatedly)
2
2
(MP3 only) Select the desired group num-
To cancel
ber. (e.g.02)
Press MODE repeatedly until "INTRO" goes out.
Notes:
• You can also select Intro play during playback.
In this case, Intro play will start from the next track after the
current track has finished.
PRESET DOWN
• You can also select Intro play during Program play mode.
Random play
3
During playback,
PROGRAM
MODE
(Repeatedly)
4
Select the desired track.
After playing all tracks, the unit stops.
To cancel
Press MODE until "RND" goes out, or press 7 to stop the disc.
Notes:
• You can also select Random play in stop mode.
• During Program play, you can not select Random play.
5
Repeat play
PROGRAM
You can repeat one track or all tracks.
During playback,
MODE
The track is registered.
1 track repeat
1 group repeat
6
For MP3, repeat steps 2-5 to select other
(Repeatedly)
(MP3 only)
tracks.
For Audio CD, repeat steps 4 and 5.
When you program exceeding 64 tracks, the program se-
quence number returns to "01" and will overwrite the previ-
ous setting.
All track repeat
To cancel
7
Press MODE repeatedly until the repeat indicator goes out.
Notes:
• You can also select Repeat play during Program play.
• You can also select Repeat play while stopped.
• To confirm the program
While stopped, press PROGRAM repeatedly. At this time, you
can add and change the program, if required.
• To delete the entire program
• While stopped, press STOP.
• Turn off the unit.
• Change the source to FM.
Hyper-Bass Sound effect
You can enjoy powerful bass sound.
7
• Play stops automatically when all the tracks have
7
been played.
For Audio CD
01
01
02:53
Track number
Group
in play
number
HOLD
Elapsed playing
OFF
ON
4
time of each track
Label side
8
3
For your reference:
Display/reference
"dISC"
Audio CD
MP3
This indication appears if 3/8 is pressed when no disc is loaded
or if the disc is not properly seated.
01
"– –"
07
0
4
00 18
00
07
Preparation period before playing the track
Flashes for several seconds after pressing 3/8 to play.
n
"OPE
"
Total number of groups
This indication appears when the lid is open.
10
Removing discs
10
35
44 48
Turn off the unit and, after the disc has stopped rotating, remove
the disc as shown below:
Total playing time
Total number of tracks
Auto power off
If the unit is left in stop mode for 30 seconds, the unit turns
itself off automatically to prevent the batteries from running
down.
Auto power off function does not work when the source is
FM.
Disc rotation noise
The portable CD player uses a power-saving operation method
so that disc rotation noise will intermittently be emitted. But, it
Group number
is not a failure.
02
0
01
Anti-Shock Protection EX
This function achieves excellent performance against sound inter-
ruption caused by vibrations. You will be able to enjoy listening
to music during (not vigorous) jogging.
By utilizing the high-performance servo circuit, audio data will be
stored in the memory ahead of time.
For Audio CD: Up to 175 seconds worth (Anti-Shock Protection
on/off selectable)
For MP3:
Up to 426 seconds worth at 128 kbps (Anti-Shock
Protection is fixed to on.)
00
Normally, this function is in effect.
00 P-01
Program sequence number
As the audio data is gradually stored, the indicator changes as follows:
ASP
PRESET UP
02
GROUP
01 P-01
To cancel
(Audio CD only)
Group number
The "ANTI SHOCK" indicator goes out.
02
01 P-01
To activate again (Audio CD only)
Press A.S.P.
Notes:
• During this operation, the disc rotates at a higher rate than usual
in order to collect extra audio data. This may cause the batteries
to run out faster and could result in a slight increase in disc rota-
tion noise.
02
030
P-01
• This function can be switched ON and OFF during playback.
However, this may cause a slight interruption in the sound be-
cause the disc's rotational speed changes.
Track number
Preventing Accidental Operation (Hold
mode)
This function causes the unit to ignore, accidental button presses.
00
Hold mode prevents the following:
00 P-02
• Powering on the unit accidentally (which can cause the batter-
ies to go dead).
• Play being cut off unexpectedly.
To use the Hold mode
(Remote Control)
(OFF)
• To prevent the unit from powering on accidentally, set the
HOLD switch to the ON position while the unit is turned off.
• To prevent the unit from unexpected operation during play, set
the HOLD switch to the ON position after you starts playing
the disc.
• When the unit is in Hold mode, "HOLD" lights as follows.
Power on : "HOLD" stays lit.
Power off : "HOLD" lights up for a few seconds when 6 or
FM is pressed.
Notes:
• Before turning on the unit, be sure that HOLD is OFF.
Otherwise, you cannot turn on the unit.
• The HOLD switch on the unit is effective for the unit only.
HBS
While, that on the remote control is effective for the remote con-
OFF
ON
trol only.
Using the Remote Control
Preparation:
Release the remote control from the Hold mode.
For MP3
Lights when a
MP3 disc is
01
02:53
used
Elapsed playing
time of each track
How to use the remote control
Track number
(in the group) in play
To start play
To stop play
To turn off the unit
Fast forward/reverse
To adjust the volume
6
Tuner Operation
You can listen to FM stations by tuning in manually, automati-
cally, or using preset memory.
For best reception, extend the headphone cord (antenna).
Manual/Auto tuning
1
FM
ASP
ANTI SHOCK
2
indicator
Select a station.
[Fully stored]
ASP
Manual tuning
Press ¢ or 4 repeatedly to select a station you want.
A.S.P.
Auto tuning
Hold down ¢ or 4 for a while and then release it. The fre-
quency automatically changes up or down to find the next station.
HOLD
OFF
ON
HOLD
(ON)
8
About MP3 files
MP3 File Compatibility
• This player can read MP3 files that are recorded in the format that is compliant with ISO 9660.
• The player can read or play an MP3 file with the extension code —".mp3".
Playing order of MP3 files
HOLD
The illustration below shows the normal playing order of the MP3 files. You will see that the MP3 files
are played back in the order from the higher hierarchy to the lower one.
Press during off or stop mode.
Press during play.
Press during stop mode.
Skip function
Press during play.
Forward
Reverse
Search function
Keep depressed during play.
When adjusting the volume using the remote control, set
the volume control on the unit to an appropriate position.
Presetting stations
You can preset up to 20 stations (frequencies).
1
Select the station you want to preset.
Use Manual or Auto tuning mentioned earlier.
2
107.0
PROGRAM
01
107.0
3
Select the preset number (01~20) you want.
PRESET UP
08
107.0
0
PRESET DOWN
Preset number
4
Press PROGRAM.
Preset tuning
1
FM
87.5
2
Select the preset number you want.
PRESET UP
08
107.0
PRESET DOWN
Preset station
Preset number
(Repeatedly)
Hierarchy
3
Group
4
MP3 file
6
7
1
8
2
9
10
5
Changing the FM reception mode
When a broadcast is in stereo, "ST." lights up and you can hear
stereo effects. However, if an FM stereo broadcast is hard to re-
ceive or noisy, you can select monaural (MONO) mode. Recep-
tion improves, but you lose the stereo effect.
To select the monaural mode
"MONO" appears.
MODE
107.0
To cancel the monaural mode
Press MODE once again. "MONO" will go out.
The monaural mode is cancelled also by changing the frequency.
Turning off the unit
• When the unit malfunctions or freezes during use, discon-
nect the power source (the AC adaptor and batteries) once.
Then, re-connect the power source and continue operation.
• If tuner operation is abnormal, press the RESET switch to
reset the unit.
RESET
Note:
The preset broadcast stations you have made will be cleared
by the reset operation.
Advertisement
