Replacing The Hard Disk Drive Fan Assembly - Lenovo ThinkStation D30 User Manual

9. Follow the following sequence to install the four screws to secure each new heat sink and fan assembly.
Do not over-tighten the screws.
a. Partially tighten screw
b. Partially tighten screw
10. Connect the heat sink and fan assembly cables to the microprocessor fan connectors on the system
board. See "Locating parts on the system board" on page 11.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 66.

Replacing the hard disk drive fan assembly

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page v.
This section provides instructions on how to replace the hard disk drive fan assembly.
To replace the hard disk drive fan assembly, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 38.
3. Disconnect the hard disk drive fan assembly cable from the system board. See "Locating parts on the
system board" on page 11.
4. Remove any parts that might prevent your access to the hard disk drive fan assembly. Depending on
your computer model, you might need to remove the PCI Express x16 graphics card for easier access to
the hard disk drive assembly. See "Installing or replacing a PCI card" on page 40.
1 , then fully tighten screw
3 , then fully tighten screw
2 , and then fully tighten screw
4 , and then fully tighten screw
.
Chapter 5 Installing or replacing hardware
1 .
3 .
55