Recording With External Recording Controls - Panasonic NV-VP33EB Operating Instruction

Recording with external
recording controls
Receiver
Aerial
VCR/DVD
Others
Tape length : AUTO( E-240)
SQPB : AUTO
OSD : 4:3
Remote : VCR 1
EXT LINK : 2
Timer Rec. LED : ON
: select
: return : exit
MENU EXIT
EL
EXT LINK
The AV2 input of this VCR is equipped for use with external equipment having
external timer recording control such as digital satellite receivers. The AV2 input
can be set to EXT LINK 1 or EXT LINK 2 depending on the equipment to be
connected. Fully wired 21-pin scart cable is required. Refer also to the
manufacturer's instruction for the external unit.
TV
Press MENU, the Menu screen appears.
With select menu Others and confirm with ENTER.
With select [EXT LINK] and turn to [2] or [1]
Press MENU to return to the Menu screen.
EXT LINK 1: The VCR recording start and stop time is controlled by a control
signal sent via the 21-pin scart cable from the external unit (e.g.
Sky Digibox).
EXT LINK 2: The VCR will start recording when AV2 input detects the video
signal and stop recording when the video signal is switched off by
the external unit.
EXT LINK
Press EXT LINK to activate the VCR´s recording stand-by mode.
Make sure the VCR´s display EL appears.
MANUAL SKIP
As long as the satellite or digital receiver transmits the special recording
signal, or a video picture is transmitted, the VCR will continue to record.
Be sure that the timer programmes stored by your VCR do not overlap with
the ones of the satellite or digital receiver. Some external equipment may not
work with this function, refer to the operating instructions for the external unit.
Quitting recording stand-by mode
EXT LINK
Press EXT LINK to quit recording stand-by mode.
The display EL disappears.
MANUAL SKIP
You can now play back a cassette, make a manual recording or watch TV.
You must press EXT LINK again to reactivate the recording stand-by mode.
.
33