Disassembly For Repair - Kenwood TKR-850 Service Manual

TKR-850
MODIFICATION / DISASSEMBLY FOR REPAIR
3-2. Connection
1. Solder the prepared coaxial cable to the final unit.
2. Connect the pin connector of the coaxial cable to CN18 of
the TX-RX unit.
Route the coaxial
cable under the lead
wire extending from
CN3 and CN16.
Style the coaxial cable as
CN18
illustrated in the figure.
TX-RX unit (A/2)
Component side
3-3. Setting the FPU
Set the channel to be used as "Simplex" using the FPU.
10
Final unit (A/2)
Component side
Solder the coaxial
cable.
CN3
CN16
Fig. 5

DISASSEMBLY FOR REPAIR

1. How to Remove the Panel Assy (ABS)
Note : You can remove the panel assembly (ABS) without
removing the top panel (A62-0840-03).
1. To remove panel (TX-RX, w), loose 6 screws ( q ).
2. To remove panel assembly (Front, r), loose 6 screws
( e ).
3. The panel assembly (ABS) is security fastened by 4 tabs
( t ) on top and bottom. You can remove the panel as-
sembly by pulling to front while you are pulling up the
RX
E
tabs.
e
e
r
w
q
q
t
t
t
t