Transporting The Product - Fujitsu AJ**A72LBTF Installation Instruction Sheet

4.2. TRANSPORTING THE PRODUCT

Transporting with ropes (Fig. 4.2-1)
• To transport the outdoor unit to the installation location by sus-
pending it, use the four cutouts that are located in the front and
back to pass a rope under the base.
• As you transport the unit, make sure the unit is vertical.
The unit could fall if you tilt the unit during transport.
• For transport, use a rope that can fully withstand the weight of
the unit.
• Do not apply shocks to the unit during transport.
• Use a protective plate to prevent the bell mouth from coming in
contact with the rope. Failure to use a protective plate can cause
the bell mouth to become deformed or damaged.
• Use 2 rope which are 8 m in length or longer.
Transporting on a forklift (Fig. 4.2-2)
• To transport the unit on a forklift, slide the forks of the forklift
through the opening between the unit and the delivery pallet.
This will enable the unit and the delivery pallet to be removed.
• Protect the unit from scratches during installation.
Transporting on a manual forklift (Fig. 4.2-2)
• To transport the unit on a manual forklift, slide the forks of the
manual forklift through the opening of the side of the delivery
pallet. This will enable the removal of the unit and the delivery
pallet.
• Protect the unit from scratches during installation.
En-6
9374241033_IM_en_p01-17.p65 6
Fig. 4.2-1
Protective boards
Rope suspension area
Fig. 4.2-2
<Side>
Fork (Manual forklift)
Delivery pallet
26/8/2008, 18:23
Product mass
About 380 kg
<Front>
Fork (Forklift)