Philips LC4.9E Service Manual page 11

4.3.6 SSB Board Cover Shield
1
2
3
Figure 4-10 SSB board cover shield
Figure 4-11 DVI-I connector and rear I/O panel screws
1. Very cautiously disconnect the LVDS cable (1) from the
SSB panel (see Figure "SSB board cover shield"). Notice
that this cable is very fragile.
2. Remove all other cables (2) from the SSB board (see
Figure "SSB board cover shield"), including the grounding
cable.
3. Remove the fixation screws (3), see Figure "SSB board
cover shield" and remove the SSB shield with the SSB
board inside, and the rear I/O panel still attached to it.
4. Remove the fixation screws (1) from the DVI-I connector
and from the rear panel, see Figure "DVI-I connector and
rear panel screws", and remove the rear I/O panel from the
SSB board.
5. Remove the upper part of the shield from the SSB panel,
by unhooking it from its brackets. Be careful not to damage
the LVDS connector on the SSB board, see Figure "SSB
board cover shield".
4.3.7 SSB Board
Figure 4-12 SSB board
2
F_15430_049.eps
1
F_15420_039.eps
1
F_15420_040.eps
Mechanical Instructions
1. Remove the two fixation screws (1) that secure the SSB
board on the lower part of the SSB shielding, see Figure
"SSB board".
2. Remove the SSB panel.
4.3.8 Power Supply Panel
3
1
100605
1. Disconnect all cables (1) from the panel.
2. Remove the fixation screws (2) from the panel.
3. Take the panel out of its brackets.
070605
070605
LC4.9E AA
2
Figure 4-13 Power supply panel
4. EN 11
F_15430_050.eps
100605