Replacing The Post-Motor Filter - Bissell 78E9 SERIES User Manual

M
aintenance and care
Cleaning the pre-motor filter continued
5. The pre-motor filter can be washed in
cold water with a mild detergent. Rinse
well and air dry thoroughly before
placing back into the tray.
6. Place the tray back into the vacuum
and replace the filter door by inserting
the tabs at the top of the door and
pushing down until it clicks into the
locked position.

Replacing the post-motor filter*

The post-motor filter is a HEPA media
filter,* which assists in the filtration
process to return clean air to the room.
1. Turn the power OFF. Unplug the vacuum
from the electrical outlet.
2. The post-motor filter is located behind
the door labeled "FILTER" on the rear of
the vacuum. Open the door by pushing
down on the tab of the door and pulling
out to remove.
3. Remove the post-motor HEPA media
filter* by grasping the handle on the
filter and pulling out to remove.
4. Replace the post-motor HEPA media
filter* with a new filter.
NOTE: The post-motor filter is a
white, pleated HEPA media filter*.
This filter* is NOT washable and
must be replaced when it
becomes dirty.
5. Replace the filter door by inserting the
two tabs at the bottom of the filter door.
Then push down on the tab on the
door and push it back into the vacuum.
Release the tab on the door to lock
into place.
*The filter media, not the vacuum as a whole,
complies with the IEST-RP-CC001.5 HEPA Standard.
11
w w w . b i s s e l l . c o m
Tip:
For maximum cleaning
performance, check the
filters often and clean or
replace if necessary.
WARNING:
Do not operate cleaner
with damp or wet filters or
without all filters in place.
2.
3.
Post-Motor HEPA
Media Filter*