Table of Contents
Advertisement
Driving tips
6. Return to the vehicle and firmly press
and
release
the
programmed
HomeLink button up to three times.
The rolling code equipped device
should now recognize the HomeLink
signal
and
activate
when
HomeLink button is pressed. The
remaining two buttons may now be
programmed if this has not previously
been
done.
Refer
"Programming" portion of this text.
5
28
Operating HomeLink
To operate, simply press the pro-
grammed HomeLink button. Activation
will now occur for the trained product
(garage door, security system, entry door
the
lock, estate gate, or home or office light-
ing). For convenience, the hand-held
transmitter of the device may also be
used at any time. The HomeLink
to
the
Wireless Controls System (once pro-
grammed) or the original hand-held
transmitter may be used to activate the
device (e.g. garage door, entry door lock,
etc.). In the event that there are still pro-
gramming difficulties, contact HomeLink
at 1-800-355-3515 or on the internet at
www.homelink.com.
Flashing
Erasing programmed HomeLink
buttons
To erase the three programmed buttons
(individual buttons cannot be erased):
• Press and hold the left and center
buttons simultaniously, until the indica-
tor light begins to flash (approximately
20 seconds). Release both buttons. Do
not hold for longer than 30 seconds.
HomeLink is now in the train (or learning)
mode and can be programmed at any
time.
MMSA5005
Hide quick links:
Advertisement
Table of Contents
