Chevrolet 2015 Impala Owner's Manual page 342

Warning
Fans or other moving engine
parts can injure you badly. Keep
your hands away from moving
parts once the engine is running.
5. Connect one end of the red
positive (+) cable to the jump
start positive (+) terminal (1).
Use a remote positive (+)
terminal if the vehicle has one.
6. Do not let the other end of the
red positive (+) cable touch
metal. Connect it to the
positive (+) terminal of the good
battery. Use a remote
positive (+) terminal if the vehicle
has one.
7. Connect one end of the black
negative ( ) cable to the
negative ( ) terminal of the good
battery. Use a remote
negative ( ) terminal if the
vehicle has one.
Do not let the other end touch
anything until the next step. The
other end of the negative ( )
cable does not go to the dead
battery. It goes to a remote
negative ( ) post on the driver
side shock tower.
8. Connect the other end of the
black negative ( ) cable to the
jump start negative (-) grounding
post (2).
9. Start the engine in the vehicle
with the good battery and run
the engine at idle speed for at
least four minutes.
10. Try to start the vehicle that had
the dead battery. If it will not
start after a few tries, it
probably needs service.
Vehicle Care
Caution
If the jumper cables are
connected or removed in the
wrong order, electrical shorting
may occur and damage the
vehicle. The repairs would not be
covered by the vehicle warranty.
Always connect and remove the
jumper cables in the correct order,
making sure that the cables do
not touch each other or other
metal.
Jumper Cable Removal
Reverse the sequence exactly when
removing the jumper cables.
10-69