Birch Log Placement - White Mountain Hearth LS-18B2-1 Installation And Owner's Manual

Log set for unvented gas log heater or vented decorative appliance models ls-18b2-1 ls-24b2-1 ls-30b2-1

Hide thumbs Also See for LS-18B2-1:

Installation instructions and owner's manual (12 pages)

Table Of Contents

Table of Contents

Before you begin: Do not, handle these logs with your bare

hands! Always wear gloves to prevent skin irritation. After

handling logs, wash your hands gently with soap and water.

All Logs

The positioning of the logs is critical to the safe and clean

operation of this heater. Sooting and other problems may

result if the logs are not properly and firmly positioned in the

appliance.

refer to figure 1 and figure 1A for the following warning.

warning: Failure to position the parts in accordance

with this diagram or failure to use only parts specifically

approved with this appliance may result in property damage

or personal injury.

PrOPer INSTALLATION SeQueNce:

LS-(18,24,30)B2-1:

(figure 1)

1. Place rear (#1) log onto two (2) pins on rear log support.

2. Place left, front (#2) log onto two (2) left, front pins on

burner pan.

3. Place right, front (#3) log onto two (2) right, front pins on

burner pan.

4. Place Y Branch (#4) onto two (2) pins on rear log.

5. Compare the completed log installation with the

appropriate photo from pages 8 through 10. Review

previous steps to make any necessary adjustments.

6. Log placement is completed.

Page 6