Sony TRINITRON KV-J21MF1AK Service Manual page 5

Getting Started
Connections
Connecting a VHF antenna or a combination VHF/UHF antenna
— 75-ohm coaxial cable (round)
Attach an optional IEC antenna connector to the 75-ohm coaxial cable.
Plug the connector into the (antenna) socket at the rear of the TV.
Rear of TV
Connecting the 3D WOOFER
p KV-J21MF1AK/J21MN1AK only
1
Attach the 3D WOOFER into the foothold on the top of the TV.
2
Connect the wires to the 3D WOOFER (8Ω) terminals at the rear of the TV.
The red wire should be connected to the ' red terminal and the black wire to the ' black terminal.
3D WOOFER
2
1
Notes
• Connect only the supplied 3D WOOFER; otherwise the TV may malfunction.
• Unplug the TV from the wall outlet when connecting the 3D WOOFER.
• To prevent a malfunction caused by a short circuit of the terminals, make sure that none of the 3D WOOFER wire strands stick out,
making contact with the neighbouring speaker terminal.
4
Getting Started
Rear of TV
On a wall
or
Black wire
Red wire
Connecting optional equipment
You can connect optional audio/video equipment to your TV such as a VCR, multi disc player, camcorder, video
game or stereo system.
Connecting video equipment using video input jacks
to antenna socket
Rear of TV
AUDIO VIDEO
R L (MONO)
VIDEO
IN
MONITOR
OUT
VIDEO IN
Front of TV
VIDEO INPUT
VIDEO AUDIO
L (MONO)
R
When using the video input jacks
Do not connect video equipment to the video input jacks at the front and the rear of your TV simultaneously; otherwise the picture will
not be displayed properly on the screen.
Connecting audio/video equipment using MONITOR OUT jacks
to antenna socket
Rear of TV
AUDIO VIDEO
R L (MONO)
VIDEO
IN
MONITOR
OUT
MONITOR OUT
When recording through the MONITOR OUT jacks
If you change the channel or video input while recording with a VCR, the channel or video input you are recording also will be changed.
to antenna
output
VCR
to video
and audio
outputs
: Signal flow
Camcorder
to video and
audio outputs
: Signal flow
Audio system
to antenna
output
VCR
or
to video
and audio
inputs
: Signal flow
Getting Started
5