Tuner Setup; Auto Tuner Setup - JVC LT-37X688 User Manual

Auto Tuner Setup

The auto tuner setup function is described on page 24 as the interactive plug-in menu. If you
need to run the auto tuner setup again, follow the steps below.
Press the M
To "Tuner Setup"
π †
è
To enter
To "Auto Tuner Setup"
π †
è
To enter
è
To choose "Cable" or "Air"
To "Scan Mode"
π †
è
To choose "Auto", "STD", "HRC" or "IRC"
To "Start"
†
Press the O
The auto tuner is finished when the message "Programming Over !" appears onscreen.
Notes:
• When the Tuner Mode is set to "Cable", it is possible to select "Scan Mode"
• If no channels were found using Auto Tuner Setup, check your antenna cable and the
settings for Tuner Mode/Scan Mode.
• You can also access the "Front Menu" screen by using the M
instead of the remote control. Choose "Auto Tuner Setup" by pressing M
panel and enter by using the C
button
ENU
button (Programming will take serveral minutes)
K
+/- (
HANNEL

Tuner Setup

– Tuner Setup > Auto Tuner Setup
+
Tuner Mode
Scan Mode
Select
ENU
è
) buttons.
Air
Auto
Start
BACK MENU
Operate Back
button on the side of the TV
† on the side
ENU
Exit
41