Four Bolt Mounting Attachments; Trailing Attachments - Gravely 810 Owner's Manual

Four Bolt Mounting
Attachments
Requires:
19075E1-
Front Drive Kit
11601E1-
Front Adapter Kit
].
Mount the Front Drive
Kit
on the tractor.
2.
Start the
Double Joint Assembly on the forward drive
shaft and on
the-
adapter
of
the
adapter
Assembly.
Slide
thc
Assembly
in
place
in
the
latches,
close
latches
and
secure
with hairpin
cotters.
Figure
20
Trailing
Attachments
Requires
ll627El
Trailing Hitch Kit.
Figare
22
816
Attach the Rear Hitch to the
Rear
Hitch
Weldment
securing
it
in
place
with the hitch
pin.
Thread
a nut on the ball stud and insert the
ball
stud down through
the rear
hitch.
Secure
in
place
with
another nut.
Insert
the
Push
Rod Guide Weldment
into the
push
rod of the Front Adapter
Kit.
Attach the Push
Rod
Guide Weldment
to ihe
Lift
Lever Shaft
Assembly
of
the tractor, Attach the push rod
to
the Adapter
Weldment.
Figure
2l
4.
Mount
attachment
to
the
Front Adapter
Kit
as
shown. Secure attachment
in
place
with two
bolts
and
two
nuts.
Stabilize
the rear hitch by tightening the bolts
against
the pad until the pad
secures
the hitch
in
a rigid
po-
sition.
Jam
the
nutl
on the bolts
against
the rear hitch
weldment.
Attach the trailing attachment to the ball stud
using
the split
socket.
Figure
23
810,812, 814
Thread
a nut on the ball stud and insert the
ball
-"-
stud down through
the rear
hitch,
Secure
in
place rvitl
another nut.
Attach the trailing
atttrchment
to the ball
stud
using
the split
socket.
3.
L2