Front Panel - Cisco CHS 435HDC Installation Manual

Front Panel

1 2
1 VOL-, VOL+ Decreases and increases the volume
2 OK
3 USB
4 CH+, CH-
5 IR Sensor
6 Display
7 Power
Note: This illustration may vary from the actual product.
CAUTION: The DVR is equipped with a hard disk drive to store programs that you
record and to allow you to rewind and pause live TV. Any time the DVR is powered on
(power LED is illuminated) or a recording is in progress (the record LED is illuminated)
the hard disk is in use.
If you need to move the DVR, complete the following steps to allow the hard disk to shut
down properly. First, make sure that no recording is in progress (record LED is off). Then,
turn off power by pressing the Power key. Finally, unplug the unit and wait 10 seconds for
the hard disk drive to spin down (stop). At this point the unit can be moved safely.
You should handle this product with the same level of care you would use when handling
other electronics containing a hard disk drive, such as a laptop computers or other hard
disk drive equipped devices.
OK
3 4
5
Selects the current item
Connects to external equipment such as a keyboard or a mouse,
software controlled
Scrolls up and down through the channels
Receives the infrared signal from the remote control
Displays the selected channel number and time of day. The display
shows the following:
• Power ( )
• Message (
• Record ( )
Turns the set-top on and off
6
• MoCA™ Link ( )
) • HDTV
• Auto
Power
7
• 480i / 480P
• 720i / 720P
• 1080i / 1080P
CHS 435HDC
T14393
• 5.1
7