Table of Contents
Advertisement
Filename [XV3EX_10Subsidiary.fm]
XV3EX_01.book Page 71 Friday, August 22, 2003 12:21 PM
Set Stations (A)
Set station names that are registered in your unit.
Perform steps A and B of "Manual Channel Set" on page 69
to access the Confirmation screen before continuing.
A
Select the item.
Press rt w e until the item you want begins blinking.
B
Access the Manual Channel Set screen.
Press OK twice.
C
Select the new station.
Press e until the station
name (ID) begins blinking,
then press rt until the new
station's name (ID) you want
to store begins blinking.
Registered station names
(
pg. 72) appear as you
press rt.
D
Switch the stations.
Press OK.
The Confirmation screen appears.
Repeat steps A – D as necessary.
E
Close the Confirmation screen.
Press SET UP MENU.
Set Stations (B)
Set station names other than the ones registered in your unit.
Perform steps A and B of "Manual Channel Set" on page 69
to access the Confirmation screen and then perform steps A
and B of "Set Stations (A)" above before continuing.
A
Select the character for station name.
Press e until the first letter of
the station name begins
blinking.
Page 71
B
Enter the new character.
Press rt to cycle through the characters (A–Z, 0–9, –,
, +,
(space) ) and stop when the desired character is
f
I
indicated, then press e to enter. Enter the remaining
characters the same way (maximum of 4). After entering
all characters, press OK.
The Confirmation screen appears.
If you make a mistake, press w until the incorrect character
begins blinking. Then enter the correct character by pressing
rt.
C
Close the Confirmation screen.
Press SET UP MENU.
NOTE:
The characters available for the station name (ID) are A–Z, 0–9, –,
, +,
(space) (maximum of 4).
f
I
Fine-Tuning Channels Already Stored
Perform steps A and B of "Manual Channel Set" on page 69
to access the Confirmation screen before continuing.
A
Select the channel to fine-tune.
Press rt w e until the channel you want to tune begins
blinking.
B
Access the Manual Channel Set screen.
Press OK twice. The Manual Channel Set screen appears.
C
Perform tuning.
Press e until "+/–" begins blinking, then press rt until
the picture is its clearest. Then press OK.
The Confirmation screen appears.
Repeat steps A – C as necessary.
D
Close the Confirmation screen.
Press SET UP MENU.
Masterpage:Right-No-Heading
71
EN
August 22, 2003 12:20 pm
Advertisement
Table of Contents
