Connection To The Hot Water Supply - Miele PW 5065 Operating And Installation Instructions

Installation and connection

Connection to the hot water supply

To keep electricity consumption costs
down this machine can be connected
to a (ring) piped hot water supply. The
maximum temperature must not exceed
70°C.
It is not economical to run it from an
individual hot water supply if it is not in
continuous use, as the water in the
supply pipes cools down and more
energy would be required to reheat the
water.
For hot water connection the same
conditions apply as for cold water
connection.
The inlet hose with the red stripes (hot
water hose) is connected to the
stopcock.
For operational reasons the machine
must not be connected to hot water
only.
54
If the machine is not connected to a hot
water supply, the water settings for the
main wash , pre-wash and rinses must
be re-programmed and the hot water
inlet hose must be detached:
^ Go to the Settings menu/Supervisor
level and select the cold option for
each of the above.
The programme durations may be
longer.
^ Unscrew the inlet hose (hot water -
red stripes)
^ Plug the inlet connection with the cap
supplied.