Remote Control Button Instructions - Magnavox RG51B1 Manual

Remote Control Button Instructions

SET TEMPERATURE( C)
AUTO FAN
COOL HIGH
Ensure the unit is plugged in and power is
DRY MED
LOW
HEAT
running. The OPERATION indicator on the
TEMP display panel of the indoor unit illuminates.
1. Press the MODE button to select AUTO.
2
3
2. Press the TEMP button to set the desired
MODE ON/OFF
FAN SPEED
1
temperature. The temperature can be set
SWING TIMER ON
ECONOMY
within a range of 17 C(62 F)~ 30 C in one
degree increments.
TIMER OFF
RESET LOCK
3. Press the ON/OFF button to start the air
LED
conditioner.
DISPLAY
NOTE
1. In AUTO mode, the air conditioner will determine
which mode to run depending on the difference between
the actual ambient room temperature and the set
temperature on the remote control.
2. In AUTO mode, you cannot switch the fan speed,
as it is being automatically controlled.
3. Change the mode to cancel AUTO mode.
SET TEMPERATURE( C) C O O
AUTO FAN
COOL HIGH
1. Press the MODE button to select COOL, HEAT,
DRY MED
HEAT LOW (cooling & heating models only) or FAN mode.
2. Press the TEMP button to set the desired
TEMP
temperature. The temperature can be set
2
4
within a range of
ON/OFF
MODE
FAN SPEED
1
degree increments.
3
3. Press the FAN SPEED button to select the
SWING TIMER ON
ECONOMY
fan speed in four steps- Auto, Low, Med,or High.
TIMER OFF
RESET LOCK
4. Press the ON/OFF button to start the air
conditioner.
LED
DISPLAY
NOTE
In the FAN mode, the set temperature and ability to
control the temperature is disabled as only the fan is
running. In this case, only step 1, 3 and 4 may be
performed.
AUTO Mode
L I N G / H E A T I N G F / A N Mode
17 C(62 F)~ 30 C by one
7
1. Press the MODE button to select DRY mode.
SET TEMPERATURE( C)
AUTO FAN
COOL HIGH
2. Press the TEMP button to set the desired
DRY MED
HEAT LOW
temperature. The temperature can be set
within a range of
TEMP
degree increments.
2
3
ON/OFF
MODE
FAN SPEED
3. Press the ON/OFF button to start the air
1
conditioner.
SWING TIMER ON
ECONOMY
TIMER OFF
RESET LOCK
NOTE
LED
DISPLAY
In the Dehumidifying mode, you can not switch
the fan speed. The fan speed will be controlled
automatically and cannot be changed.
SWING
Use the SWING button to adjust the Up/Down
SET TEMPERATURE( C)
airflow direction .
AUTO FAN
HIGH
COOL
1. When press the button once and quickly, the
DRY MED
HEAT LOW
air flow direction setting feature of the louver is
TEMP
activated. The moving angle of the louver is
6 for each press. Keep pressing the button to o
ON/OFF
MODE move the louver to the desired position.
FAN SPEED
NOTE:On some models this initiates the
1
SWING TIMER ON
ECONOMY
TIMER OFF
RESET LOCK
2. By pressing and holding down the SWING
LED
button for 2 seconds, the auto swing feature
DISPLAY
of the louver is activated. The horizontal
louver would swing up/down automatically.
Press it again to stop.
DEHUMIDIFIER Mode
17 C(62 F)~ 30 C in one
Mode(on some models)
Auto swing feature only.
8