Table of Contents
Advertisement
For Parts Call K&T 606-678-9623 or 606-561-4983
SERVICE AND ADJUSTMENTS
BELT INSTALLATION -
•
Work belt around both mandrel pulleys and idler pulleys.
•
Make sure belt is in all pulley grooves and inside all belt
guides.
•
Install mower (See "To Install Mower" in this section of
manual).
IDLER PULLEYS
MANDREL
PULLEY
MANDREL
PULLEY
FIG. 23
TO ADJUST BRAKE (See Fig. 24)
Your tractor is equipped with an adjustable brake system
which is mounted on the side of the transaxle.
If tractor requires more than six (6) feet stopping distance at
high speed in highest gear on a level dry concrete or paved
surface, then brake must be adjusted.
•
Depress clutch/brake pedal and engage parking brake.
•
Measure distance between brake operating arm and nut
"A" on brake rod.
•
If distance is other than 1-3/4", loosen jam nut and turn
nut "A" until distance becomes 1-3/4". Retighten jam nut
against nut "A".
•
Road test tractor for proper stopping distance as stated
above. Readjust if necessary. If stopping distance is
still greater than six (6) feet in highest gear, further
maintenance is necessary. Contact your nearest au-
thorized service center/department.
WITH PARKING BRAKE "ENGAGED"
1-3/4"
DO NOT TOUCH THIS NUT. IF FURTHER BRAKE
ADJUSTMENT IS NECESSARY CONTACT YOUR NEAR-
EST AUTHORIZED SERVICE CENTER/DEPARTMENT
FIG. 24
TO REPLACE MOTION DRIVE BELT
(See Fig. 25)
Park the tractor on level surface. Engage parking brake. For
assistance, there is a belt installation guide decal on bottom
side of left footrest.
BELT REMOVAL -
•
NOTE: Observe entire motion drive belt and position of all
belt guides and keepers.
•
•
•
•
•
•
BELT INSTALLATION -
•
•
•
•
•
•
•
•
ELECTRIC
CLUTCH
NUT "A"
JAM NUT
OPERATING
ARM
22
www.mymowerparts.com
Remove mower (See "TO REMOVE MOWER" in this
section of manual).
Disconnect clutch wire harness.
Remove clutch locator.
Remove belt from stationary idler and clutching idler.
Remove belt downward from engine pulley and around
electric clutch.
Pull belt slack toward rear of tractor. Carefully remove
belt upwards from transmission input pulley and over
cooling fan blades.
Remove belt from center span keeper and pull belt away
from tractor.
Carefully work new belt down around transmission cool-
ing fan and onto the input pulley.
Slide belt into the center span keeper.
Pull belt toward front of tractor and roll belt around electric
clutch and onto engine pulley.
Install belt through stationary idler and clutching idler.
Reinstall clutch locator and tighten nut securely.
Reconnect clutch harness.
Make sure belt is in all pulley grooves and inside all belt
guides and keepers.
Install mower (See "TO INSTALL MOWER" in this
section of manual).
CLUTCHING
IDLER
STATIONARY
IDLER
CENTER SPAN
KEEPER
TRANSMISSION
INPUT PULLEY
FIG. 25
CLUTCH LOCATOR
CLUTCH
WIRE
HARNESS
Advertisement
Table of Contents
