Table of Contents
Advertisement
Chapter
3
Installation and Connection
Installation and Connection
This chapter explains how to install and connect DS-L3 and a DS camera head.
3.1
Installing DS-L3
Cautions on installation
When you install DS-L3, make sure that there is at least a 10-cm space between DS-L3 and other objects so that heat is
released from DS-L3.
3.1.1
Using Standard Stand for Installation
Install DS-L3 on a horizontal surface such as a desktop when
using the standard stand.
Unfold the arm of the standard stand, and adjust its angle so that
the touch panel stands at a desirable tilt angle.
Mounting on Commercially Available Arm
3.1.2
DS-L3 can be mounted on a commercially available arm of VESA 75 mm, or on a commercially available stand or mount of
UL 1678.
Use one that suits the following conditions:
• DS-L3 weight:
• Mounting screw hole:
• Screw tightening torque:
Described here is a procedure for fixing DS-L3 to a commercially available arm.
Cautions on the built-in monitor
Be careful not to damage the surface of the built-in monitor in this procedure.
1
Remove the four screws and the standard stand at the back of DS-L3.
2
Fix the commercially available arm to DS-L3 using the four screws that have been fixing the standard stand.
To tighten and remove the screws, use a cross slot screwdriver for M4 screws.
Caution: Be sure to mount DS-L3 on a stand or the like.
After removing the standard stand, be sure to mount DS-L3 on a commercially available arm, stand, or mount before
using it. After removing the standard stand, do not use DS-L3 leaning on something because it may fall over.
3
Chapter 3
Installation and Connection
1.8 kg
M4, depth 7 mm
80 to 120 N･cm
Remove the
standard stand.
Adjust the
arm angle.
10
Fix it on a
commercially
available arm.
Advertisement
Table of Contents
