Connection To Ac Outlet; Ac Convenience Outlets; Remote Control; External Decoder Connection - Marantz 4270 Instructions Manual

Terminals work as shown in Figure 13.
1) Press terminal in
2) Insert speaker wire
3) Release terminal
CONNECTION TO AC OUTLET
With the front panel POWER pushswitch "OUT",
plug the line cord into an electrical outlet supply­
ing the proper voltage.
CAUTION: DO NOT PLUG YOUR MODEL
4270 INTO A DC OUTLET, AS
SERIOUS DAMAGE WI LL OCCUR.
AC CONVENIENCE OUTLETS
Two AC outlets, one switched and one unswitch ­
ed, are provided on the rear panel to supply
power to associated components of the system
(tape recorder, record player, etc.), The maxi­
mum power available from the SWITCHED and
UNSWITCHED AC OUTLETS is 100 Watts and
200 Watts, respectively.
REMOTE CONTROL
The R EMOTE CONTROL connector and switch
are intended for use only with the optional
Model RC-4 Remote Control. The REMOTE
CONTROL Switch assigns control of loudness,
balance and volume to the optional RCA Remote
Control. WHEN THE RC-4 IS NOT USED,
THE REMOTE CONTROL SWITCH MUST BE
IN THE LOCAL POSITION.
EXTERNAL DECODER CONNECTION
A pocket on the bottom of the chassis will ac­
commodate Marantz 4-channel decoders, such as
the Model SQA-1. For use, follow the instruc­
tions supplied with the optional decoder.
TAPE RECORDING
Instructions for connecting a recorder and playing
back a tape are given in "SOURCE DEVICES",
page 4.
To record, select the desired program source,
using the SELECTOR Switch. Put the recorder
connected to the TAPE MONITOR OUT jacks
"1 or 2" in the record mode.
For additional information, refer to MODE
SWITCH on page 7, and MONITOR SWITCH
on page 8.
3. RELEASE THE
TERMINAL
Figure 13. Quick-Connect Speaker Terminal
2. INSERT SPEAKER WIRE
INTO TERMINAL
1. PRESS END OF
TERM INAL IN
13